There are a number of these toroidal winding machines on youtube, though unfortunately I have not seen any yet that wind toroidal cores in the sizes used for general “consumer” electronics ...

The O-Core toroidal power transformer cores enable the production of transformers that are 15% smaller in size and weight than traditional toroidal transformers.

The higher the molybdenum content, the lower the permeability. A wider bandwidth is also gained by a low µ. For reasonable wire diameters, as found in low-medium switching power supplies, a good ...

Westbury, N.Y. – Sprague-Goodman Electronics has beefed up its line of surface-mount toroidal-core transformers. The newest models measure 8.5 x 6 x 4.5 mm, in a pick-and-placeable liquid-crystal ...

I wound 30 turns on a toroid core, made some measurements, broke and superglued it, and made some more measurements. Using a voltage divider with a carbon resistor driven at 1 KHz, the inductance ...

The toroid solution for a 160-nH V CORE inductor (Pulse PA2142NL) again uses a 14-perm, 0.44-0D powder core with five turns of 17-GA wire. This design has a footprint of 14.5 mm × 14 mm, ...

LP32 — a 4-1/8-inch inside diameter toroid, good for the really big AC and RF cables (again, this won’t fit over a 3-1/8-inch EIA flange, so keep that in mind when planning) LA52 — a small (1/4-inch ...

Milestone: On May 26th 2025, the Divertor Tokamak Test (DTT) project celebrated the completion of its first superconducting toroidal magnet.